Uploaded image for project: ' AGL Development'
  1. AGL Development
  2. SPEC-4799

AGL not booting up in imx8mq-evk board when build using octopus and master branch



      I build an AGL demo platform image for imx8mq-evk board but the board was not booting up. Boot log gets stuck at 'starting kernel message'. This was observed in octopus and master branch.

      Below shows the boot log :

      U-Boot SPL 2022.10+fslc+gcbd7eb17ac (May 10 2023 - 06:26:40 +0000)
      PMIC:  PFUZE100 ID=0x10
      SEC0:  RNG instantiated
      Normal Boot
      Trying to boot from MMC2

      U-Boot 2022.10+fslc+gcbd7eb17ac (May 10 2023 - 06:26:40 +0000)

      CPU:   Freescale i.MX8MQ rev2.0 at 1000 MHz
      Reset cause: POR
      Model: NXP i.MX8MQ EVK
      DRAM:  3 GiB
      clk_register: failed to get <NULL> device (parent of ckil)
      clk_register: failed to get <NULL> device (parent of clock-osc-27m)
      clk_register: failed to get <NULL> device (parent of sys1_pll)
      clk_register: failed to get <NULL> device (parent of sys2_pll)
      clk_register: failed to get <NULL> device (parent of sys3_pll)
      Core:  148 devices, 21 uclasses, devicetree: separate
      MMC:   FSL_SDHC: 0, FSL_SDHC: 1
      Loading Environment from MMC... *** Warning - bad CRC, using default environment

      In:    serial@30860000
      Out:   serial@30860000
      Err:   serial@30860000
      SEC0:  RNG instantiated
      Error: ethernet@30be0000 address not set.

      Error: ethernet@30be0000 address not set.
      No ethernet found.

      Hit any key to stop autoboot:  0 
      Card did not respond to voltage select! : -110
      switch to partitions #0, OK
      mmc1 is current device
      Scanning mmc 1:1...
      Found /extlinux/extlinux.conf
      Retrieving file: /extlinux/extlinux.conf
      1:      i.MX8M Quad EVK
      Retrieving file: /extlinux/../Image
      append: root=/dev/mmcblk1p2 rootwait rw console=ttymxc0,115200
      Retrieving file: /extlinux/../imx8mq-evk.dtb
      Moving Image from 0x40480000 to 0x40600000, end=428c0000

        1. Flattened Device Tree blob at 43000000
             Booting using the fdt blob at 0x43000000
             Loading Device Tree to 000000004fff4000, end 000000004ffffb32 ... OK

      Starting kernel ...


        No reviews matched the request. Check your Options in the drop-down menu of this sections header.

            scottm Scott Murray
            shilpajohn Shilpa John
            1 Vote for this issue
            5 Start watching this issue