Hi,

I build an AGL demo platform image for imx8mq-evk board but the board was not booting up. Boot log gets stuck at 'starting kernel message'. This was observed in octopus and master branch.

Below shows the boot log :

U-Boot SPL 2022.10+fslc+gcbd7eb17ac (May 10 2023 - 06:26:40 +0000)
PMIC:  PFUZE100 ID=0x10
SEC0:  RNG instantiated
Normal Boot
Trying to boot from MMC2

U-Boot 2022.10+fslc+gcbd7eb17ac (May 10 2023 - 06:26:40 +0000)

CPU:   Freescale i.MX8MQ rev2.0 at 1000 MHz
Reset cause: POR
Model: NXP i.MX8MQ EVK
DRAM:  3 GiB
clk_register: failed to get <NULL> device (parent of ckil)
clk_register: failed to get <NULL> device (parent of clock-osc-27m)
clk_register: failed to get <NULL> device (parent of sys1_pll)
clk_register: failed to get <NULL> device (parent of sys2_pll)
clk_register: failed to get <NULL> device (parent of sys3_pll)
Core:  148 devices, 21 uclasses, devicetree: separate
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from MMC... *** Warning - bad CRC, using default environment

In:    serial@30860000
Out:   serial@30860000
Err:   serial@30860000
SEC0:  RNG instantiated
Net:   
Error: ethernet@30be0000 address not set.

Error: ethernet@30be0000 address not set.
No ethernet found.

Hit any key to stop autoboot:  0 
Card did not respond to voltage select! : -110
switch to partitions #0, OK
mmc1 is current device
Scanning mmc 1:1...
Found /extlinux/extlinux.conf
Retrieving file: /extlinux/extlinux.conf
1:      i.MX8M Quad EVK
Retrieving file: /extlinux/../Image
append: root=/dev/mmcblk1p2 rootwait rw console=ttymxc0,115200
Retrieving file: /extlinux/../imx8mq-evk.dtb
Moving Image from 0x40480000 to 0x40600000, end=428c0000

1. 1. Flattened Device Tree blob at 43000000
         Booting using the fdt blob at 0x43000000
         Loading Device Tree to 000000004fff4000, end 000000004ffffb32 ... OK

Starting kernel ...