-
Bug
-
Resolution: Fixed
-
Major
-
None
-
None
-
None
-
None
Hi,
I followed the links to eLinux.org from docs.automotivelinux.org article Update the firmware stack but unfortunately the procedure didn't work as expected. I am using an image built from AGL master. I getting the following errors when I try to boot my m3ulcb:
[ 0.000192] NOTICE: BL2: R-Car Gen3 Initial Program Loader(CA57) Rev.1.0.16 [ 0.005756] NOTICE: BL2: PRR is R-Car M3 Ver1.0 [ 0.010338] NOTICE: BL2: Board is Starter Kit Rev1.0 [ 0.015365] NOTICE: BL2: Boot device is HyperFlash(80MHz) [ 0.020791] NOTICE: BL2: LCM state is CM [ 0.024832] NOTICE: BL2: AVS setting succeeded. DVFS_SetVID=0x53 [ 0.030813] NOTICE: BL2: DDR3200(rev.0.27)NOTICE: [WARM_BOOT]ERROR: Warm booting... The potential of GP-1-8 did not switch to Low. If you expect the operation of cold boot, check the board configuration (ex, Dip-SW) and/or the H/W failure. [ 0.057401] NOTICE: [BOOT_STATUS_UPDATE_ERROR]NOTICE: ..1 [ 0.062932] NOTICE: BL2: Failed to DRAM initialize (-1). [ 4.999834] ERROR: [ 5.000626] ERROR: BL2: System WDT overflow, occured address is 0xe631142c
I have found a similar issue reported in GitHub.
Any ideas how to fix it?
Best regards,
Leon
- duplicates
-
SPEC-1143 R-Car M3 Boot error
- Closed